If the factory wants to use an injection molding machine manipulator, then you need to know the precautions before introducing the robot:

◆ Several premises

1. The whole factory should have the concept of automation and the determination to introduce automation;

2, the company's orders are relatively stable: including the order quantity and product structure are basically the same;

3, the company's mold: 1) After the mold is designed, the concept of "following the use of the robot" should be taken into consideration. For example, do not have a big undercut, manual access is very difficult, the robot does not take it. Ideal, and so on; 2) The company's existing mold structure under the guidance of professional robot manufacturers, can be improved at any cost to improve, only to make up their minds, can successfully introduce the automation of the robot into your company;

◆ Preparation

1. Air source: prepare or add air compressor, prepare air freeze dryer;

2, a certain length of the trachea;

3. Injection molding machine instructions; etc.

◆ Some problems that may occur after the robot is installed

1. The skill of your technicians is not enough, which results in the use rate of the robot is not high. For example, different products need to adjust different fixtures, and the technicians are unskilled and cannot adjust; this phenomenon has been educated by our technicians. Plus the groping of your technicians will slowly disappear;

2, some of the existing molds can not be used to make the robot can not be used, the only way to do this is to change the mold or not use the robot;

◆Manipulator's post-maintenance and maintenance

1. The warranty period of our company is one year, and the whole machine is maintained for life;

2. Every month, our company has regular inspections;

3. The machine should be regularly maintained during the use, such as regular wiping, regular filling of lubricating oil, etc.;

4, the machine speed is moderate, let it move gently during the molding cycle;

5, be careful not to hit the robot when the upper and lower molds; otherwise it is very easy to cause the machine circuit short circuit or shape deformation;